It can be installed in front and rear end of a vehicle or in wind shield. The proper placing of radar detector shall reduce the maximum false alarms production in the radar detector. The location of radar detector shall now be given proper care as it touches most parts of the wires and signals are produced.

This article shall help you to guide how to hardwire the radar detector. The procedures are made so easy in such a way that even you can hardwire your radar detector in your own vehicle or car. Best position of radar detector should be free from any sort of front and rear end obstacles. Most of them do not give proper attention and care to have such a long wire connection for a radar detector before it touches the lighter.

So this hard wire shall help you in preventing the radar detector movement towards the cigarette lighter. To avoid the damages to radar detector it is good if you do it for yourself always. The instruction manual that come along with the radar detector device shall help you at any time and can be troubleshoot as put in simple words.

In order to hard wire your radar detector in your vehicle the following are things to be in place just before you start processing. The things such as radar detector kit, hard wire kit, cutters for cutting the wire, wire strippers and zip ties are required to hard wire radar detector.

To start with find where interior fuse box is fixed in your car or vehicle. The foremost important shall be given to instruction manual which helps for successful hard wiring. Go through the instruction manual and try to understand which wire is fuse wire for radio, ignition and cigarette lighter. In addition to this find the fuse which has direct power supply for vehicle which can be switched on and put off.

This fuse for power supply should have a constant supply of power or voltage at least most of the times during the operation. Trace the screw on fuse box and locate them easily so that the ground wire that is black wire which has come with the kit is connected. If you find or notice the fuse of any of the wires may it be radio wire, ignition wire or cigarette lighter wire it should be pulled out first.

If once the fuse wire is removed, soon after replace them back to it spots with the red wire otherwise referred to as red wire. Ensure whether the hot or red wire is always in contact with the metal leg part of the fuse. The power supply cord shall be taken from the kit and put it on. Now the radar detector should be put on.

This shows whether your vehicle is either on or off mode. The excess wire, which is remaining hard wire which are all along the headliner edge. It can also be on the lowest end point of the dash and can be easy and snug. The excess wire shall be gathered together in such a way that the unused are hidden somewhere inside the box fuse box which could not be seen. The excess shall be collected together and zipped using zip tie and can be kept in such a place where it is not reachable or not visible.

Let the excess wire shall also be kept near fuse box so that in case of emergency preparedness it reduces unwanted pressure. Now your car or vehicle is hard wired as desired and can be accessed by an individual. This hard wiring of radar detector ensures there are no more wires running here and there in front of the sight. Make sure that your car or vehicle is switched off and key is also out of ignition point.

Otherwise it starts messing up with the fuse box. Extra care is required when you are not in a vehicle as fuse wire may lit the cigarette wire. When proper care is taken the wire will not get plugged in the cigarette lighter socket. The radar detector is usually placed below the mirror. The either white wire or gray wire shall be replaced in place of power supply cord and it can further be pushed away when it is not noticed. The radar detector wiring is active only when the key is put on. The problems with radar detector shall now be made easy by hardwiring.